Cisco 200-301 Cisco Certified Network Associate Exam Exam Practice Test Questions

• Question 1

  What is a function of a Next-Generation IPS?

  • Makes forwarding decisions based on learned MAC addresses
  • Serves as a controller within a controller-based network
  • Integrates with a RADIUS server to enforce Layer 2 device authentication rules
  • Correlates user activity with network events

  Show Answer Answer: D Next

• Question 2

  Which network action occurs within the data plane?

  • Compare the destination IP address to the IP routing table.
  • Run routing protocols (OSPF, EIGRP, RIP, BGP)
  • Make a configuration change from an incoming NETCONF RPC
  • Reply to an incoming ICMP echo request

  Show Answer Answer: A Next

• Question 3

  Which action is taken by a switch port enabled for PoE power classification override?

  • When a powered device begins drawing power from a PoE switch port a syslog message is generated
  • As power usage on a PoE switch port is checked data flow to the connected device is temporarily paused
  • If a switch determines that a device is using less than the minimum configured power it assumes the device has failed and disconnects
  • Should a monitored port exceeds the maximum administrative value for power, the port is shutdown and err-disabled

  Show Answer Answer: D Next

• Question 4

  Refer lo the exhibit. What is the next-hop P address for R2 so that PC2 reaches the application server via ElGRP?

  • 192.168.30.1
  • 10.10 105
  • 10.10.10.6
  • 192.168.201

  Show Answer Answer: D Next

• Question 5

  What is recommended for the wireless infrastructure design of an organization?

  • Group access points together to increase throughput on a given channel
  • Configure the first three access points are configured to use Channels 1, 6, and 11
  • Include a least two access points on nonoverlapping channels to support load balancing
  • Assign physically adjacent access points to the same Wi-Fi channel

  Show Answer Answer: B Next