Cisco 300-410 Implementing Cisco Enterprise Advanced Routing and Services Exam Practice Test Questions

• Question 1

  Refer to the exhibit.Which routes from OSPF process 5 are redistributed into EIGRP?

  • E1 and E2 subnets matching access list TO-OSPF
  • E1 and E2 subnets matching prefix list TO-OSPF
  • only E2 subnets matching access list TO-OSPF
  • only E1 subnets matching prefix listTO-OS1

  Show Answer Answer: A Next

• Question 2

  Refer to the exhibit.Refer to the exhibit. R2 has two paths to reach 192.168.13.0/24. but traffic is sent only through R3. Which action allows traffic to use both paths?

  • Configure the bandwidth 2000 command under interface FastEthernet0/0 on R2.
  • Configure the variance 4 command under the EIGRP process on R2.
  • Configure the delay 1 command under interface FastEthernet0/0 on R2.
  • Configure the variance 2 command under the EIGRP process on R2

  Show Answer Answer: B Next

• Question 3

  Refer to the exhibit.Why is the remote NetFlow server failing to receive the NetFlow data?

  • The flow exporter is configured but is not used.
  • The flow monitor is applied in the wrong direction.
  • The flow monitor is applied to the wrong interface.
  • The destination of the flow exporter is not reachable.

  Show Answer Answer: A Next

• Question 4

  Refer to the exhibit.After redistribution is enabled between the routing protocols; PC2, PC3, and PC4 cannot reach PC1. Which action can the engineer take to solve the issue so that all the PCs are reachable?

  • Set the administrative distance 100 under the RIP process on R2.
  • Filter the prefix 10.1.1.0/24 when redistributed from OSPF to EIGRP.
  • Filter the prefix 10.1.1.0/24 when redistributed from RIP to EIGRP.
  • Redistribute the directly connected interfaces on R2.

  Show Answer Answer: A Next

• Question 5

  Refer to the exhibit.Which action adds the 10 1 7.6-32 route to the BGP table?

  • Add a static roue for the 10 1 7 &32 network
  • Add the network 10.1.7.6 mask 255.255.255.255 backdoor command
  • Add summaty-address10.1.7.6.255.255.2550
  • Add the network 10.1.7.6 mask 255.255.255.255 command

  Show Answer Answer: D Next