Cisco 300-510 Implementing Cisco Service Provider Advanced Routing Solutions Exam Practice Test Questions

• Question 1

  Refer to the exhibit.R1 is directly connected to R2 and R3. R1 is in BGP AS 123, R2 is in BGP AS 2, and R3is in BGP AS 3. Assume that there is no connectivity issue between R1, R2 and R1, R3. Which result betweenBGP peers R1, R2 and R1, R3 is true?

  • The BGP session does not come up between R1 and R2 and between R1 and R3.
  • The BGP session comes up between R1 and R2 and between R1 and R3.
  • The BGP session comes up between R1 and R3, but not between R1 and R2.
  • The BGP session comes up between R1 and R2, but not between R1 and R3.

  Show Answer Answer: B Next

• Question 2

  Which two routing protocols have extensions capable of running SRv6? (Choose two.)

  • OSPF
  • BGP
  • RIP
  • IGRP
  • EIGRP

  Show Answer Answer: A, B Next

• Question 3

  Refer to the exhibit.Refer to the exhibit. Mid-sized company Z connected two branch offices via a multicast-enabled ISP using the BGP routing protocol. PIM was implemented to support multicast streaming between the branches via MSDP Client A cannot connect to the multicast stream source of company Z. The network engineer ran a debug on the edge of the network as shown. Which action resolves the issue?

  • Implement MBGP and enable a multicast address family on R2
  • Configure the PIM protocol on the Serial 1/1 interface and enable Auto-RP
  • Deploy BSR on routers R1 and R2 and enable multicast on both LAN segments.
  • Enable the BGP routing protocol and advertise the 10 10.10.0/24 subnet on R1.

  Show Answer Answer: C Next

• Question 4

  Refer to the exhibit.What is the effect of this configuration?

  • It sets the keepalive timer to 30 milliseconds and the hold timer to 240 milliseconds.
  • It sets the keepalive timer to 30 seconds and the hold timer to 240 seconds.
  • It sets the hold timer to 30 milliseconds and the keepalive timer to 240 milliseconds.
  • It sets the hold timer to 30 seconds and the keepalive timer to 240 seconds.

  Show Answer Answer: B Next

• Question 5

  Refer to the exhibit.Refer to the exhibit Router 1 resides in a different data center than Rouler 2 and Router 3. Router 1 is running the IS-IS routing protocol, and it is preconfigured with LDP and segment routing Which configuration must the engineer apply under router isis 111 on Router 1 to implement Tl-LFA on the link to Router 2 without disrupting traffic to Router 3?A)B)C)D)

  • Option A
  • Option B
  • Option C
  • Option D

  Show Answer Answer: D Next