Cisco 300-515 Implementing Cisco Service Provider VPN Services (SPVI) Exam Exam Practice Test Questions

• Question 1

  Drag and drop the EVPN components from the left onto the correct planes on the right.

  Show Answer Answer:

  

  

  

  

  

  

  

  

  

  

  

  

  

  

  

  

  

  

  

  

  

  

  

  

  

  

  Next

• Question 2

  While implementing Layer 3 MPLS VPN, which feature should an engineer use at the PEs to transform the customer IPv4 prefixes into a unique 96-bit prefix

  • RT
  • VC ID
  • RD
  • PW ID

  Show Answer Answer: C Next

• Question 3

  You are writing the requirements for an MPLS L3VPN environment that uses MP-BGP between PE routers. In this environment, route targets and route distinguishers need to be advertised between the PE routers.Which three operations meet these requirements? (Choose three.)

  • mandatory creation of PE-to-PE BGP sessions between the outgoing interface IP addresses
  • advertisement of standard communities, enabled on the PE-to-PE BGP neighbors
  • creation of PE-to-PE BGP sessions between loopback IP addresses
  • full mesh of IBGP sessions
  • full mesh of EBGP sessions and partial mesh of IBGP sessions
  • advertisement of extended communities, enabled on the PE-to-PE BGP neighbors

  Show Answer Answer: C, D, F Next

• Question 4

  Refer to the exhibit.If the two devices are operating normally, which two conclusions can you draw from this configuration? (Choose two.)

  • CE1 must use OSPF to establish a neighbor relationship with PE1.
  • PE1 labels the routes it learns from CE1 with the route-target 222:2 and shares them with its VPNv4 peers.
  • PE1 labels the routes it learns from CE1 with the route-target 111:1 and shares them with its VPNv4 peers.
  • The PE-CE routes between the devices are being exchanged by OSPF
  • CE1 is supporting CSC.

  Show Answer Answer: A, D Next

• Question 5

  Refer to the exhibit.Which statement describes the result of this configuration?

  • R1 redistributes BGP routes into the OSPF process of VRF custabc as E1 routes.
  • R1 redistributes BGP routes into the OSPF process of VRF custabc as E2 routes.
  • R1 mutually redistributes routes between BGP 65001 and the OSPF process of VRF custabc.
  • R1 redistributes BGP routes into the OSPF process of VRF custabc as OIA routes.

  Show Answer Answer: A Next