Cisco 300-620 Implementing Cisco Application Centric Infrastructure (300-620 DCACI) Exam Exam Practice Test Questions

• Question 1

  The unicast routing feature is enabled on the bridge domain. Which two conditions enable the Cisco ACI leaf to learn a source IP as a local endpoint? (Choose two.)

  • Through Ethernet traffic received in a bridge domain.
  • IP traffic routed through an SVI.
  • Through VXLAN traffic received on the uplink.
  • IP traffic routed through a Layer 3 Out.
  • Through ARP received on an SVI.

  Show Answer Answer: B, E Next

• Question 2

  An organization deploys active-active data centers and active-standby firewalls in each data center. Which action should be taken in a Cisco ACI Multi-Pod to maintain traffic symmetry through the firewalls?

  • Disable Resilient Hashing.
  • Disable service node Health Tracking.
  • Enable Pod ID Aware Redirection.
  • Enable Endpoint Dataplane Learning.

  Show Answer Answer: B Next

• Question 3

  An engineer is configuring ACI VMM domain integration with Cisco UCS-B Series. Which type of port channel policy must be configured in the vSwitch policy?

  • LACP Active
  • MAC Pinning
  • LACP Passive
  • MAC Pinning-Physical-NIC-load

  Show Answer Answer: A Next

• Question 4

  An engineer is extending an EPG out of the ACI fabric using static path binding. Which statement about the endpoints is true?

  • Endpoints must connect directly to the ACI leaf port.
  • External endpoints are in a different bridge domain than the endpoints in the fabric.
  • Endpoint learning encompasses the MAC address only.
  • External endpoints are in the same EPG as the directly attached endpoints.

  Show Answer Answer: C Next

• Question 5

  A Solutions Architect is asked to design two data centers based on Cisco ACI technology that can extend L2/ L3, VXLAN, and network policy across locations. ACI Multi-Pod has been selected. Which two requirements must be considered in this design? (Choose two.)

  • ACI underlay protocols, i.e. COOP, IS-IS and MP-BGP, spans across pods. Create QoS policies to make sure those protocols have higher priority.
  • A single APIC Cluster is required in a Multi-Pod design. It is important to place the APIC Controllers in different locations in order to maximize redundancy and reliability.
  • ACI Multi-Pod requires an IP Network supporting PIM-Bidir.
  • ACI Multi-Pod does not support Firewall Clusters across Pods. Firewall Clusters should always be local.
  • Multi-Pod requires multiple APIC Controller Clusters, one per pod. Make sure those clusters can communicate to each other through a highly available connection.

  Show Answer Answer: B, C Next