Cisco 300-630 Implementing Cisco Application Centric Infrastructure - Advanced Exam Exam Practice Test Questions

• Question 1

  What are two characteristics of Cisco ACI and Spanning Tree Protocol interaction? (Choose two.)

  • When a TCN BPDU is received in a VLAN, Cisco ACI flushes the endpoints for the associated encapsulation.
  • STP BPDUs are dropped due to MCP.
  • MST BPDUs are flooded correctly in Cisco ACI fabric without additional configuration.
  • BPDU filter and BPDU guard can be configured on Cisco ACI leaf edge ports.
  • Cisco ACI must be configured as the STP root for all VLANs.

  Show Answer Answer: D, E Next

• Question 2

  How is multicast traffic managed in a Cisco ACI fabric?

  • FTag trees are rooted at the spine nodes. Cisco APIC determines the roots.
  • FTag trees are rooted at the leaf nodes. Cisco APIC determines the roots.
  • FTag trees are rooted at the leaf nodes. The roots must be configured manually.
  • FTag trees are rooted at the spine nodes. The roots must be configured manually.

  Show Answer Answer: A Next

• Question 3

  An engineer configures a new Cisco ACI Multi-Pod and must set up the link between the spine and the IPN device. Which three actions should be taken to accomplish this goal? (Choose three.)

  • Enable MP-BGP routing
  • Enable BIDIR-PIM protocol
  • Enable PIM-SM protocol
  • Enable OSPF routing
  • Enable IS-IS routing
  • Enable DHCP relay

  Show Answer Answer: A, B, F Next

• Question 4

  An engineer is implementing the Cisco ACI fabric but is experiencing loops detected from endpoints. When the issue was investigated, it was discovered that the packets are received with the same source IP address but from different leaf switch ports. The engineer must prevent the issue from happening in the future and make sure that the port is brought back up if it was disabled due to the loop discovered. Which set of actions must be taken to meet these requirements?

  • Enable the enforce endpoint check and set the Rouge EP detection interval
  • Enable the rogue endpoint and set the Error Disabled Recovery Policy
  • Enable the remote endpoint limit and set the Interface override
  • Enable reverse path forwarding and set the Hold Interval

  Show Answer Answer: B Next

• Question 5

  A network engineer configured an active-active firewall cluster that is stretched across separate pods in the Cisco ACI fabric. Which two implementation setups for anycast services are available? (Choose two.)

  • Modify the Cisco ACI contract scope
  • Modify the MAC address on the second firewall
  • Configure the firewalls behind an EPG subnet
  • Deselect No Default SVI Gateway under EPG Subnet
  • Deploy a Layer 4 to Layer 7 service graph with PBR

  Show Answer Answer: B, C Next