Cisco 352-001 Cisco Certified Design Expert Written Exam Exam Practice Test Questions

• Question 1

  How must the queue sizes be designed to ensure that an application functions correctly?

  • The default queue are good for any deployment as it compensates the serialization delay.
  • Each individual queuing delay in the chain must be less than or equal to the application required delay.
  • The sum of the queuing of all devices plus serialization delay In the chain must be less than or equal to the application required delay.
  • The queuing delay on every device in the chain must be exactly the same to the application required delay.

  Show Answer Answer: C Next

• Question 2

  You have been tasked with designing a data center interconnect to provide business continuity You want to encrypt the traffic over the DCI using IEEE 802 1AE MACsec to prevent the deployment of any firewall or IPS. Which two interconnect technologies support MACsec? (Choose two.)

  • EoMPLS
  • MPLS Layer 3 VPN
  • DMVPN
  • GET VPN
  • KVPLS

  Show Answer Answer: A, E Next

• Question 3

  The CTO of XYZ is having some high-level discussions about IPv6 implementation and is considering whether XYZ should consider the MPLS IPv6 Provider Edge approach. Which two drawbacks of the MPLS IPv6 Provider Edge approach are true? (Choose two)

  • XYZ must migrate the IGP used in the MPLS core network to the multitopology IS-IS architecture to support MPLS IPv6 Provider Edge technology
  • The label allocation mode is per-prefix. so the label table grows as the BGP table increases
  • MPLS P routers cannot send ICMPv6 messages because they are not enable for IPv6
  • Single RIB and FIB is required for each connected customer, so scalability issues can arise
  • Single IGP topology must be deployed, which can cause scalability issues in the future

  Show Answer Answer: C, D Next

• Question 4

  What is the most common IoT threat vector?

  • Attacks against programming errors in IoT devices
  • Insertion of invalid inputs that cause denial of service
  • Physical access to IoT devices that are installed in non-secure locations
  • Human error and social engineering to access supervisory control systems.

  Show Answer Answer: A Next

• Question 5

  Refer to the exhibit. As the new network designer for a manufacturing company. You are designing this resilient. Ethernet ring of the plant Ethernet network that is connected to the core, which does not use STP. Both edge ports are on the same switch in a ring segment. There is connectivity between the edge ports throughout the segment, so you can create a redundant connection between any two switches in the ring. Which three characteristics of this design are true? (Choose two)

  • If all ports in the segment are operational, then two ports are in the blocked state for each VLAN
  • If VLAN load balancing is configured, then one port in the segment controls the blocked state of VLANs
  • If all ports in the segment are operational, then one port is in the blocked state for each VLAN
  • If a link fails then the alternate ports quickly unblock. When the failed link comes back up, a logically blocked port per VLAN is selected with minimal disruption to the network
  • If a link fails then the alternate ports Quickly unblock. When the failed link comes back up. a physically blocked port per VLAN is selected with minimal disruption to the network

  Show Answer Answer: C, D Next