Free NSE6_FWF-6.4 Practice Questions and Answers | Updated 2025

• Question 1

  Which two phases are part of the process to plan a wireless design project? (Choose two.)

  • Project information phase
    
  • Hardware selection phase
    
  • Site survey phase
    
  • Installation phase
    

  Show Answer Answer: 3,,4 Next

• Question 2

  A tunnel mode wireless network is configured on a FortiGate wireless controller.Which task must be completed before the wireless network can be used?

  • The wireless network interface must be assigned a Layer 3 address
    
  • Security Fabric and HTTPS must be enabled on the wireless network interface
    
  • The wireless network to Internet firewall policy must be configured
    
  • The new network must be manually assigned to a FortiAP profile.
    

  Show Answer Answer: 3 Next

• Question 3

  When configuring Auto TX Power control on an AP radio, which two statements best describe how the radio responds? (Choose two.)

  • When the AP detects any other wireless signal stronger that -70 dBm, it will reduce its transmission power until it reaches the minimum configured TX power limit.
    
  • When the AP detects PF Interference from an unknown source such as a cordless phone with a signal stronger that -70 dBm, it will increase its transmission power until it reaches the maximum configured TX power limit.
    
  • When the AP detects any wireless client signal weaker than -70 dBm, it will reduce its transmission power until it reaches the maximum configured TX power limit.
    
  • When the AP detects any interference from a trusted neighboring AP stronger that -70 dBm, it will reduce its transmission power until it reaches the minimum configured TX power limit.
    

  Show Answer Answer: 1,,3 Next

• Question 4

  As a network administrator, you are responsible for managing an enterprise secure wireless LAN. The controller is based in the United States, and you have been asked to deploy a number of managed APs in a remote office in Germany.What is the correct way to ensure that the RF channels and transmission power limits are appropriately configured for the remote APs?

  • Configure the APs individually by overriding the settings in Managed FortiAPs
    
  • Configure the controller for the correct country code for Germany
    
  • Clone a suitable FortiAP profile and change the county code settings on the profile
    
  • Create a new FortiAP profile and change the county code settings on the profile
    

  Show Answer Answer: 3 Next

• Question 5

  What type of design model does FortiPlanner use in wireless design project?

  • Architectural model
    
  • Predictive model
    
  • Analytical model
    
  • Integration model
    

  Show Answer Answer: 1 Next