HP HPE0-S59 HPE Compute Solutions Exam Exam Practice Test Questions

• Question 1

  Which statement about the SY480 Gen10 Plus Compute Module is true?

  • It cannot be mixed with Gen9 compute modules in the same frame.
  • It supports 8 memory channels and memory DIMMs of up to 256GB.
  • It only supports NVDIMM Persistent Memory.
  • It supports "3rd Gen AMO EPYC Server Processors with 64 cores.

  Show Answer Answer: C Next

• Question 2

  Your customer has an HPE Synergy frame equipped with a D3940 Storage Module. Each of the compute nodes has an appropriate storage controller Installed and two 12Gb SAS switches installed in the first fabric.The customer reports that compute nodes cannot access the storage module. What should you verify first when troubleshooting this problem?

  • If the D3940 module is imported in managed state that allows volume provisioning.
  • If there Is a logical interconnect created based on the 12Gb SAS switches.
  • If the D3940 storage module is property licensed through HPE OneView interface.
  • If there is at least one ISCSI network configured that will provide access to the module.

  Show Answer Answer: A Next

• Question 3

  Which statement about login redistribution is true?

  • Login redistribution is available only If HPE Primera or HPE Alletra is connected directly to the HPE Synergy frame
  • Login redistribution is a licensed feature and the number of licenses required depends on the number of active ports
  • Login redistribution is supported only on the HPE Synergy Virtual Connect SE 32Gb FC Modules
  • Login redistribution is used for login balancing when they are not distributed evenly over the FC links

  Show Answer Answer: C Next

• Question 4

  Your customer plans to use HPE Primera to boot HPE Synergy compute nodes. They currently have two HPE Virtual Connect SE 100Gb F32 Module for Synergy modules installed in the frame. The customer wants to use FC as a storage access protocolWhat must be done to complete this task?

  • Enable FC primary and secondary boot on the modules through the HPE OneView interface
  • FC connectivity on the modules should be enabled through the service console by disabling FCoE.
  • Add FC upgrade licenses in HPE OneView that will enable FC connectivity for the modules
  • Enter both modules into a maintenance mode, then enable FC connectivity through CLI

  Show Answer Answer: B Next

• Question 5

  Your customer experienced some problems caused by outdated HPE Superdome Flex firmware.Which update method should they use to avoid these issues in the future?

  • HPE OneView method for I/O firmware update procedure
  • RMC CLI to update I/O and HPE Persistent Memory firmware
  • HPE OneView IT HPE Persistent Memory firmware must be updated.
  • HPE SUM if HPE Persistent Memory firmware must be updated

  Show Answer Answer: B Next