Huawei H19-424_V1.0 HCSP-Presales-Campus Network Planning and Design V1.0 Exam Exam Practice Test Questions

• Question 1

  In the fabric network of dual-border node networking of the campus distributed gateway scheme, cross-networking is recommended between the core device and the aggregation device, so that a L3VXLAN tunnel will be created between the two border nodes and the edge node.

  • And the two upstream traffic paths of the edge form ECMP load balancing
  • Different source CIDR blocks choose different main exits
  • Different EDGE devices choose different main outlets
  • Different upstream network segments choose different main exits

  Show Answer Answer: B Next

• Question 2

  The description of the intelligent routing strategy of the LAN &WAN convergence solution is incorrect

  • Support setting the active/standby link based on the application/application group, and intelligently select the link for data forwarding
  • LTE can only be used as an escape link
  • The link intelligent handover conditions include packet loss, delay, and jitter
  • Support bandwidth conditional traffic selection

  Show Answer Answer: B Next

• Question 3

  Which of the following does not belong to the planning and design of a virtual network?

  • VN planning and design
  • Strategy design
  • Deployment automation design

  Show Answer Answer: C Next

• Question 4

  The opcode parameter description in SRv6 basic data plan is incorrect ()

  • The static Opcode needs to be configured within the static segment range to prevent conflicts with the Opcode dynamically allocated by the IGP protocol. The static segment length range is determined by the static static-length parameter of the locator command.
  • End-op, and end-m need to be statically configured
  • End, end-x, end-dt4, end-dt6, and end-dx2 can be dynamically assigned or statically configured
  • The SRv6SID format is Locator:Function:Args, where the Args field is also called Opcode

  Show Answer Answer: D Next

• Question 5

  The description of the main controller of the CloudEngine S8700 switch is incorrect.

  • 04, 06, and 10 main control boards cannot be shared
  • The main controller does not provide a business port
  • The main control and switching are integrated, and the centralized architecture has a lower switching delay
  • 1:1 primary/standby in the frame, primary/standby switchover and packet loss < 5ms

  Show Answer Answer: B Next